2000 Chevrolet Blazer - Spindle And Axle Washer

1 - 18 of 18 results for Spindle And Axle Washer

Dorman AutoGrade Spindle Nut Washer - 05309

Part #:
05309
Line:
MTM
Multiple Applications
Material:   Steel
Inside Diameter (in):   1 Inch
Inside Diameter (mm):   25mm

Dorman AutoGrade Spindle Nut Washer - 618-005

Part #:
618-005
Line:
DOR
Spindle Nut Washer   Front; Rear Wheel Drive
Material:   Steel
Inside Diameter (in):   3/4 Inch
Outside Diameter (in):   1-5/8 Inch

Dorman AutoGrade Spindle Nut Washer - 618-057

Part #:
618-057
Line:
DOR
Multiple Applications
Material:   Steel
Inside Diameter (in):   1 Inch
Inside Diameter (mm):   25mm

BrakeBest Select Rear Brake Rotor - 56725RGS

Part #:
56725RGS
Line:
BBR
Brake Rotor   Rear; 5 Lug; Rear Wheel Drive; With 2.86 Inch Overall Height
Construction:   Full Cast
Material:   Cast Iron (G3000)
Style:   OE Equivalent

BrakeBest Select Front Brake Rotor - 56694RGS

Part #:
56694RGS
Line:
BBR
Brake Rotor   Front; 5 Lug
Construction:   Full Cast
Material:   Cast Iron (G3000)
Style:   OE Equivalent

BrakeBest Select Drum/Rotor/Hub Rear Brake Rotor - 56707RGS

Part #:
56707RGS
Line:
BBR
Multiple Applications
Construction:   Full Cast
Material:   Cast Iron (G3000)
Style:   OE Equivalent

What is an Axle or Spindle Washer?


The spindle or axle washer evenly distributes the force of tightening the spindle nut and protects the nut and the bearing from damage. It's placed between the nut and the bearing and can help with hub assembly and bearing load. When servicing wheel bearings, it is important to install the spindle washer appropriately. It will often have a key and fit over the spindle shaft only one way. In most cases, your service manual will also specify the appropriate amount of preload, and will require you to torque the spindle nut over the spindle washer to specification. The spindle nut and washer may also be secured with a spindle nut retainer and/or cotter pin to prevent the nut from backing off while you drive. If you replace your wheel bearings and your spindle washer is missing or damaged, it should be replaced before you complete the repair. The washer is imperative to the assembly of the wheel end, and is there to shield the bearing from the points on the axle nut, as the edges of the nut can cause damage to your new wheel bearings if they are in direct contact. For your next wheel bearing or hub repair, shop O'Reilly Auto Parts for replacement wheel bearings, wheel seals, wheel bearing grease, axle nuts, nut retainers, and spindle washers for a complete repair.