Specialty Products Adjustable Control Arms With Ball Joints - 25455

Improve droop travel, drivability and tire wear as well as adjusting tire position in your wheel well with SPC's adjustable front upper control arms. Featuring an upgraded greaseable ball joint and SpecRide bushings, this arm is designed to correct alignment angles while maintaining factory ride quality. SPC's integrated tubular and cast steel designs provide the strength and durability needed for the most demanding environments. These remove and replace arms are sold in pairs.

Get more droop travel: SPC's arm has improved clearance to get around the spring bucket. With 80 degrees of articulation in the upgraded ball joint and free pivoting bushings, SPC's arm gives you maximum droop travel.

Get your drivability and tracking back: When you lift your truck you affect caster and camber. SPC's arms have +1 degree of caster built into them. Using its patented ball joint design the arm will get you 0 to +4 degrees of caster and +/- 2 degrees of camber, so you can put your alignment angles back to specification.

Get your tire where you want it in the wheel well: Use adjustment in the control arm and on the OE lower cams to maximize alignment angles and move oversized tires forward in the wheel well to minimize or avoid fender trimming.

Do you need heavy duty rear lower control arms? Check out SPC part number 25955, which are more than 2x stronger than the OE arms.

• Adjustment Range: Camber +/- 2.0 degrees, Caster -1.0 degree to +3.0 degrees
• Installation time: .8 hr./side
• Replacement Ball Joint Kit Available
• Replacement Bushing Kit Available
• Replacement Boot Kit Available